Redundant Power Supply Settings

Solace PubSub+ appliances use redundant AC hot-swappable power supplies.

PubSub+ 3530s and 3560s use two redundant AC hot-swappable power supplies—one installed power supply meets the system requirements, and the second installed power supply provides redundancy, load sharing, and increased system availability.

You can configure the redundant power supply parameter that raises syslog event message when the number of active power supplies detected on the appliance is less than the configured power redundancy parameter.

To configure the redundant power supply setting on a Solace PubSub+ appliance, enter the following CONFIG command:

solace(configure)# hardware power-redundancy <type>

Where:

type specifies the redundant power supply configuration to use for the appliance.